Industrial Cooling Tower/Cooling Tower
1. Type: Steel structure and concrete structure FRP casing.
2. Cooling tower of capacity for one cell: 800 to 4500m3/H,
3. Body frame for cooling tower: A. JBNG series: Made up by steel bar, round and square steel pipe. All componentsare hot dip galvanized or handled with other special embalmment. Thus it isanticorrosion and high intensity.
4. Casing: Made of reinforced compound material. The body surface is imported colorizedgel-coat surface, which contains ultraviolet radiation absorbefacient.
5. Drive system: Use horizontal shaft drive gear reducer. For easier maintenance, motor is fixed outside fan stack while oil ruler outside fan stack.
6. Distribution system: Use distribution pipe fixed with advanced gravitational nozzlein the world. It may work at low water supplier pressure, sprinkle water equally, and never jam.
7. Sprinkling fill: Use high efficient PVC fill. The piece mould is tested by authoritydepartment, compared to other fill, it has such advantages as larger surface, small air resistance, good hydrophile, large heat transfer coefficient,
8. Eliminator and louver: Use national advanced special three-dimensional eliminator, impact of which is rather remarkable, with drift loss of less than 0.005 percent.
9. Guarantee of cooling capacity: Designed strictly on GB 7190.2-1997 and advanceddesign idea in the world; Tested in Jinling Thermal Performance Test Lab, whichis built on CTI standard. Production is controlled and guaranteed by ISO9001 andISO14001.&